Every file here is free to download, and you can add your own logo.

Free Cut-Out Name Sign Generator

Bold raised letters in the font you like, on a base trimmed to match their outline. There’s room for a logo too, and two colors need just one filament swap.

Loading…

About the Cut-Out Name Sign

This is the name sign for a shelf, a wall, a nursery, a gaming setup, or a booth table, where the outline of the letters is the whole design. With no frame around it, the shape changes completely with the font, from a looping script to blocky capitals. It scales from a small shelf piece up to a sign as big as your bed allows.

Examples

As it starts, then a few other ways it can look.

  • Cut-Out Name Sign as it starts
  • Cut-Out Name Sign, example 1
  • Cut-Out Name Sign, example 2, with a logo beside the name
  • Cut-Out Name Sign, example 3, with a logo beside the name
  • Cut-Out Name Sign, example 4
  • Cut-Out Name Sign, example 5, with a logo beside the name

At a glance

Letter height:
15–200 mm
Name:
up to 14 characters on each of 2 lines, in 37 fonts
Colors:
Base; letters; logo (a third, with a filament changer)
Per download:
up to 31 names
Prints:
flat, face up

As it starts

For “Ellie” with 40 mm letters, before you change anything. The numbers under the preview follow your name, letter height, and font.

Size:
102.5 × 55.8 × 5.5 mm
Color change at:
3 mm
Filament:
under 23 g PLA

Ideas for it

  • A nursery name above the crib in a soft, rounded script
  • A gamer tag or streaming handle for the wall behind the monitor
  • A shop name with its logo above, for a craft fair table
  • Two lines for a couple’s names, or a first and last name

This is the sign on our cheer spirit stick, clipped to a dowel with pom-poms on both ends. See how it’s made.

Printing the Cut-Out Name Sign

The letters stand on a base trimmed to follow them, and that base is always joined into one piece, so no letter is left floating. Border sets how far the base reaches past the letters. Blend fills the gaps between them until the outline becomes one smooth shape.

At bigger sizes, a wide flat print can lift at its ends; a clean bed, a glue stick, and a brim keep it down. The letters stand taller here than on most of our designs, casting a strong shadow on a wall.

If a long name hits your bed’s limit, splitting it onto a second line lets the letters grow larger.

One spool? Pause at the color change and swap by hand; your download gives the exact height.

Questions about the Cut-Out Name Sign

How do I hang it without screws?
There are no holes in this one, so use removable adhesive strips or double-sided mounting tape on the back. On a big sign, spread several strips across the base.
Can it go outside?
PLA softens in direct sun and heat, so outdoors it can sag or warp over a summer. PETG or ASA holds up far better in sun and weather.
Will thin script letters snap off?
The base under them carries the load, so they’re sturdier than they look. A wider Border gives fine strokes more support, and more Blend turns the sign into one solid shape.

Downloading it

Free once you sign in with Google, in files for 22 printers or any slicer. Downloads and files.