Free Wine Glass Name Tags to 3D Print
A small name tag on a snap-on clip that grips the stem of a wine glass, so every guest can find their drink again. Two colors, one filament swap.
Loading…
About the Drink Tag
A drink tag clips onto the stem of a wine glass so each guest can find their glass again after setting it down. It’s made for weddings, dinner parties, holiday tables, and tastings, where every glass on the table looks the same. A single download can cover the whole guest list.
Examples
As it starts, then a few other ways it can look.
At a glance
- Letter height:
- 6–20 mm
- Name:
- up to 12 characters, in 33 fonts
- Colors:
- Tag and clip; letters; logo (a third, with a filament changer)
- Per download:
- up to 150 names
- Prints:
- flat, face up
As it starts
For “Ellie” with 9 mm letters, before you change anything. The numbers under the preview follow your name, letter height, and font.
- Size:
- 34.4 × 14.8 × 4 mm
- Color change at:
- 2.6 mm
- Filament:
- under 2 g PLA
Ideas for it
- Gold names on white tags for a wedding reception
- Place-setting favors that guests take home
- A star or snowflake beside each name for a holiday dinner
- Initials or nicknames for a wine tasting with friends
- Tags in the party’s colors for a bridal shower or anniversary
Printing the Drink Tag
The clip is an open ring on one side of the tag, with a narrow gap and a flared mouth so it snaps over a stem and stays. It prints flat in the tag color, with the letters raised in the second color. Set the Glass clip size close to the thickness of your stems.
These are tiny and come in big batches, so the whole set shares a plate and needs only one pause. A brim or glue stick keeps such small parts from breaking loose mid-print, and with this many pieces a clean first layer matters most.
For a clip that flexes without snapping, PETG is the better choice; PLA works but can crack if it’s pried open too far. Test one tag on your actual glasses before you print a hundred.
One spool? Pause at the color change and swap by hand; your download gives the exact height.
Questions about the Drink Tag
- Will it fit my glasses?
- Measure a stem and set the clip size to match. Stemless glasses and tumblers give the clip nothing to grab, so these are for stemmed glasses.
- Can I make tags without names?
- Yes, the name is optional here, so you can make a run of tags that carry only an icon or logo.
- Can they go in the dishwasher?
- Take them off first. Hot water can soften and warp PLA; PETG copes better with heat, but washing the tags by hand is kindest to them.
Downloading it
Free once you sign in with Google, in files for 22 printers or any slicer. Downloads and files.